Brake System
BR-5
Disassembly
Note:
Be careful not spray the brake liquid on the painted
area, otherwise it will damage the painting surface; if it
dose, clean it immediately with clean water.
Avoid bending, twisting and stretching of all the hoses
too much when disassembling.
1.Use a nylon pipe to connect the exhaust valve.
2.Depress the pedal several times to exhaust all the liquid
out of the valve.
3.Loosen the nut of the hose mouth connected with the brake.
4.Whenever cut off the hydraulic pipes, block the open with clean staff to
avoid dust entering.
Check
Check whether there is any crack, wear of the brake piping (pipes and
hoses), replace if there is.
Installation
Note:
Add new liquid of "901-4".
Do not use exhausted and unclean liquid.
1.Tighten all the expansion nuts and bolts.
Tightening torque of the nuts: 15~18N.m
Tightening torque of the bolts: 17~20N.m
2.Add new liquid until it flows out from the valve.
3.Exhaust air based on the above steps.
To Next Page
Loading...