Rear Axle & Rear Suspension
RA-11
Check
Check if there are any crack on leaf spring. If there are, replace the spring.
Check if there are any abrasion, crack, distortion or damaged screw thread on front bracket, shackle, U type
bolt and gasket. If there are any, replace the parts when necessary.
Check if there are any distortion or craze on all sleeves, replace them when necessary. Make sure that sleeves
are correctly assemblyed.
Assembly
1.Wiper suds on rubber sleeve.
2.Assembly shackle and front pin and tighten the nuts by hand.
3.Assembly supporting plate and nut below leaf spring
or axle housing.
4.Tighten U type bolt in diagonal.
Tighten U type bolt to make them all in the same
length on the scew thread part below the suporting plate.
5.Assembly shork absorber and tighten nuts by hand.
6.On non-load condition shake vehicle to eliminate the
damp of leaf spring.
7.Thighten shackle, front pin and nut of shock
absorber.
To Next Page
Loading...