Maintenance Section
-206-
Checking Element
1. Insert a light inside the clean dry element and
examine it. Discard the element if tears, rips or
damage are found.
2. Wrap and store good elements in a clean, dry
place.
Brake Oil Level - Check
The brake reservoir is located on the left side of the
steering column.
1. Remove the filler cap.
2. Maintain the brake fluid level to the fluid level
mark on the brake system reservoir.
3. Clean and install the filler cap
Hydraulic Oil Level – Check
WARNING
At operating temperature, the hydraulic tank is
hot and under pressure.
Hot oil can cause burns.
Remove the filter cap only when the engine is
stopped, and the cap is cool enough to touch
with your bare hand. Remove the filter cap
slowly to relieve pressure.
1. Operate the lift truck for a few minutes to warm
the oil. Park the lift truck on a level surface, with
the forks lowered, mast tilted back, parking
brake engaged, transmission in NEUTRAL and
the engine stopped.
2. Raise the hood and seat assembly. Make sure
the air lift cylinder securely holds the hood
open.
3. Remove the dip stick/filter cap. Maintain the oil
level to the FULL mark on the dip stick/filter
cap.
To Next Page
Loading...
Need help?
General
