Operation Section
-84-
Dual Fuel System
Changing From Gasoline to LP –
Gas
NOTE: The Underwriter’s Laboratory (U.L.)
requires that the gasoline tank must be at
least one - quarter full when operating on
LP. This will allow the lift truck to be
restarted on gasoline and moved to an
approved refueling area, when operating in
a hazardous area.
1. Park the lift truck level in an authorized refueling
area with the forks lowered, the parking brake
applied, the transmission in NEUTRAL and the
engine running.
2. Move lever (1), on the fuel selector switch to the
OFF (2) position. Leave lever (1) in this position
until the engine stops.
3. Move lever (1) to the LPG (3) position.
4. Open the fuel valve, on the LP tank, by slowly
turning the valve counterclockwise.
5. Turn the ignition switch key to the OFF position
and then to the START position to start the
engine. Release it when the engine starts.
Changing From LP to Gasoline
1. Park the lift truck level in an authorized
refueling area with the forks lowered, the
parking brake applied, the transmission in
NEUTRAL and the engine running.
2. Close the fuel valve on the LP tank. hood open.
1
2
3
4
To Next Page
Loading...
Need help?
General
