Maintenance Section
-234-
Every 2000 Service Hours or Yearly
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures
.
Engine Valve Lash (Diesel Engine
Only) – Check, Adjust
See topic “Engine valve Lash (Diesel Engine Only)
– Check, Adjust”. In First 250 Service hours.
Steer Wheel Bearings -
Reassemble
Park the lift truck level with the forks lowered,
parking brake engaged, transmission in NEUTRAL
and the engine stopped.
NOTE: The procedure is shown on a GC-Series lift
truck. It is the same for D, G-Series lift
trucks.
Typical Example
1. Lift the steer wheels off the ground. Place
stands or blocking under the frame and steer
axle to support the lift truck.
Typical Example
2. Remove the hub cap which is pressed into the
wheel hub.
To Next Page
Loading...