OP000509Inspection, Maintenance and Adjustment
4-6
Before Service Read
• Read the Operator's Manual and the decals/labels
and instructions found on the machine to obtain
the required knowledge and information about the
machine.
• To be able to carry out the service work in a
correct way, it is important that the correct tools
and equipment be used. Replace or repair broken
tools and faulty equipment.
• When lifting the machine, the frame joint must be
locked and the machine lifted at the eyes
intended for this purpose. See “Summary of
Safety Precautions for Lifting” on page 5-2
• Use a hard hat, safety glasses, protective shoes
and gloves and an approved respirator or other
protective articles when required.
• Do not wear loose fitting clothing or jewelry.
• Keep service surfaces and handholds clean from
oil, dirt and ice.
• Use the stepping areas provided with antislip
protection to avoid the risk of slipping. Worn,
painted over, or loose protections must be
replaced. Remember that high-pressure water jets
when washing and spilled oil can cause the
protections to loosen. Do not direct the water jet
against the protections and wipe up spilled oil.
• Make sure that there is sufficient ventilation when
starting the engine indoors.
• Do not exceed the maximum permissible floor
load.
• Do not stand in front of or behind the machine
while the engine is running.
• Use a ladder when changing light bulbs or
carrying out other service work high up on the
machine.
Figure 4
Figure 5
FG008056
Figure 6
To Next Page
