G643(E) Service Manual Chapter 1. General Information 8
Replacement Part
When oil seal, O-ring, packing and gasket have
been removed, be sure to replace them with new
parts.
However, rocker cover gasket may be reused if it is
not damaged.
Rubber Parts
Do not stain timing belt and V-belt with oil or water.
Therefore, do not clean the pulley and sprocket with
detergent.
Oil and Grease
Before reassembly, apply specified oil to the rotating
and sliding parts.
Genuine Part
When the part is to be replaced, be sure to use
genuine part.
For selection of appropriate parts, refer to the Parts
Catalog.
Electrical System
1. Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
2. Never pull on the wires when disconnecting
connectors.
3. Locking connectors will click when the connector
is secure.
4. Handle sensors and relays carefully. Be careful
not to drop them or hit them against other parts.
To Next Page
Loading...
