Doosan G643E - Installation

G643(E) Service Manual Chapter 4. Engine Electrical System 139
Starter Repair
Removal
Remove or disconnect
WARNING
Always disconnect the cable at the battery
before you make repairs to the engine.
Disconnect the cable at the negative terminal
first. Install a tag on the battery terminals first.
Install a tag on the battery terminals so that no
one connects the cable on the terminal.
1. Discount battery negative cable at negative
terminal.
2. Disconnect the battery positive cable at positive
terminal.
3. Put labels on wires and cables prior to
disconnecting to aid in correct installation.
4. Disconnect wires and cables from starter.
5. Hold starter so it won’t fall. Remove capscrews
that fasten the starter to the flywheel housing.
Install capscrews to fasten the starter to the
flywheel housing.
Installation
Install or connect
1. Place starter in position in flywheel housing.
Install capcrews to fasten the starter to the
flywheel housing. Tighten cap screws to 38 N•M
(28 lb•ft)
2. Connect wires and cables as labeled in removal.
3. Connect the battery positive cable at positive
terminal.
4. Connect battery negative cable at negative
terminal.