DORMA CS 80 MAGNEO
5
Safety requirements according to DIN 18650 in the Full Energy mode
www.dorma-magneo.com
CS 80 MAGNEO
The actuating forces are also limited in this mode. However, due to the higher contact
forces that can occur, a safety kit must be installed. This must be done by a specialist in
accordance with DIN 18650 or equivalent national safety regulations.
Risk assessment on the part of the installer
Special requirements regarding the protection of people in need of protection
1.4 Limitation of liability
CS 80 MAGNEO
DORMA GmbH + Co. KG
1.5 Documentation
Using control elements, making adjustments or performing procedures that are not
described herein might cause electric shocks, danger caused by electric voltage/current
and/or dangers due to mechanical incidents.
It is important for your personal safety to abide by the instructions mentioned in this
documentation. An incorrectly performed installation of the system might cause serious
injuries.
1.6 General information regarding the installation of the system
The CS 80 MAGNEO must be disconnected from power supply (de-energized) when
performing mounting or installation work. Remove the power plug, or, in case of
permanent power supply, switch off fuse.
Special spatial conditions and certain user groups might make it sensible to equip the
application with safety sensors even when the system is operated in Low-Energy-Mode.
Whether this is required or not has to be assessed with the aid of an individual risk
assessment and must be considered during the planning of the system and by the
manufacturer, i.e. the party performing the installation of the system.
We would therefore ask you to have a look at our risk assessment form , which is
available on our homepage and will help you to perform the risk
assessment.
In case the risk assessment reveals that there is a health risk or risk of injury when the
door hits a user in an unacceptable way, additional protection via safety equipment
(connection of safety sensors) is required. This is especially necessary when people in
need of protection (children, elderly people or disabled people) use the door.
These safety devices must be installed by a specialist in accordance with DIN 18650 or
equivalent national safety regulations.
The must only be used according to its specified standard operation.
will not accept any liability for damages resulting from
unauthorized modifications of the .
Please keep this documentation for later reference.
Secure the working area against unauthorized access of other people.
Falling items or tools might cause injuries.
In any case, the way of mounting and the mounting equipment, like for example screws
and wall plugs, have to be adequate with regard to the structural conditions (concrete,
wood, plasterboard etc.)
·
·
To Next Page
Loading...
Need help?
General
