DORMA CS 80 MAGNEO
6
CS 80 MAGNEO - Awarded safety
Developed according to the latest safety standards:
Low-Energy-Mode in accordance with DIN standard
Tested Safety
- mark
The TÜV certificate and the certificate can be obtained
from the manufacturer on demand.
·
·
As soon as you have relaxed the screws of the end stop, both the end stop and the carrier
could fall out of the operator. Therefore you should always hold the operator straight.
Pay attention that no water or other liquids drop on or into the .
The carrier contains strong permanent magnets and must not be removed.
Never stick metal objects inside the openings of the .
Otherwise you could sustain an electric shock.
Never put you hand inside the in order to avoid injuries.
Only specially qualified staff may open the power supply housing.
Lay the power cord so that nobody can trip over the cable or unplug it by mistake.
Do not operate the when the power cord is damaged.
Always pull at the plug and never at the cable when unplugging the power supply.
Only operate the mains switch at the header profile while the door stands still or is
permanently open.
No pushbuttons/switches, pictures etc. must be located within the door's movement
range. Baseboards have to be removed if required.
Following the successful installation of the system, you have to check the settings as well
as the and the safety devices for proper functioning.
The installation described herein is only an example. Structural or local conditions,
available tools or other conditions might suggest a different approach.
·
·
·
·
·
·
·
·
·
·
·
CS 80 MAGNEO
CS 80 MAGNEO
CS 80 MAGNEO
CS 80 MAGNEO
CS 80 MAGNEO
· This device must not be disposed of as domestic waste.
To Next Page
Loading...
Need help?
General
