Dorma PORTEO - Determine Swing Direction; Determine Open Position

DORMA PORTEO
WN 057472 45532 02/08
Standard commissioning
- Open door by approximately 5°.
Determination of swing direction:
- Move door to desired position.
The LED (green) blinks.
- Press service key once.
The LED emits a permanent light for 3 sec.,
then it blinks
The door determines this position as its
position.
The door travels to its position.
The LED (green) emits permanent light.
Determination of "open" position:
"open”
"open"
"closed"
Following the learning cycle, the PORTEO door assistant is ready for operation.
adjustments page 22 and 23
Now you can perform further adjustments like speed, hold-open time or adjustments regarding
the optional accessories like for example the electric strike, see .
3
- Press service key and
switch on power switch.
Press and hold service key for 8 sec. until
the door starts moving, then release the
service key.
The LED (green) blinks.
The door determines the swing direction and
travels to its position.
Determination of swing direction:
Simultaneously, until the door starts moving,
"closed"
5°
4
5
6
max. 110°
LED
0
FF
0
N
LED
0F
F
0N
Service pushbutton
GB 15