Dover markem-imaje SmartDate 5 - Page 163

SECTION 5 - TROUBLESHOOTING
5-17
SmartDate 5 06/08
Warning Message 2110 - Low Ribbon Tension Corrected During Print
Possible
Causes
Adjustments were made to correct the ribbon tension during a
print.
Remedial
Action
Warning message cleared by operator action.
Warning Message 2111 - End of Ribbon Detaected
Possible
Causes
The end of ribbon sensor has detected the end of the ribbon.
Remedial
Action
Warning message cleared by operator action.
Warning Message 2112 - End of Ribbon Sensor
Possible
Causes
The End of Ribbon sensor requires calibrating.
Remedial
Action
Warning message cleared by operator action.
Warning Message 2113 - Relative Motion Missed Print
Possible
Causes
The substrate was moving when the Print Go signal was
received.
Remedial
Action
Warning message cleared by operator action.
Warning Message 2114 - Relative Motion Spoiled Print
Possible
Causes
The printer failed to complete the print. The substrate moved
during print.
Remedial
Action
Warning message cleared by operator action.
Warning Message 2115 - Missing Lines from Print
Possible
Causes
Loss of print quality due to the substrate speed slowing during
printing.
Remedial
Action
Warning message cleared by operator action.
Table 5– 2: Warning Messages