3. Connect the 12-3004 RJ45 Cable:
a. Connect one end of the cable to the CN4 Connector of the DPC interface board.
b. Put the other end of the cable through an open knockout hole in the bottom of the terminal.
c. The routing of the cable should be around the inside of the terminal so it is out of the way of
internal components.
d. Connect the other end to RS-232 Port 4 of the FSC.
INFORMATION: The illustration above shows the ports as they are seen from the top of the
FSC3000. Port 4 is the one on the left of the back row of RS-232 ports.
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 57
To Next Page
Loading...