87
English
6. Operation
6.1
Getting Started
➋
Dish Setup
1. Press the MENU button to display the main menu.
2. Use and to move in the menu.
3. Press OK on ‘Dish Setting’. The following window will appear. <Figure 6.1.2>
✽ Note: Enter a 4-Digit password if need arise. The default password is ‘0000’.
4. Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
▪ Satellite: Select any satellite by pressing buttons.
▪ Frequency: If the default TP frequency is not appropriate, you can select another
TP frequency at which to check for signal.
▪ LNB Power: Select among ON/OFF/13V/18V.
▪ LNB Type: Select among Single/Universal/OCS/SaTCR.
▪ LNB Freq: Set the frequency of the LNB oscillator.
▪ 22KHz: When not AUTO, set the signal path from LNB or switch by selecting a control signal
among 0/22KHz.
▪ DiSEqC 1.0/1.1: Select DiSEqC protocol among OFF/1.0/1.1 as appropriate for your
configuration.
▪ Rename: Change the name of satellite.
(if selected Russian Language that Support Russian keypad)
▪ Beep On/Off: Beep Sound as signal level.
5. Auto Scan: Press Red button the remote to begin Auto Scan.
Figure 6.1.2
[2012.10.12]D15+F15_russian+english.indd 87 2012-10-12 11:23:05
To Next Page
Loading...