91
English
6. Operation
6.1
Getting Started
Figure 6.1.6 Figure 6.1.7
➌
Satellite Channel Search
▣ Auto Scan <Figure 6.1.6>
1. To select more than one satellite, press the OK button when the selection bar is positioned on
the satellite.
2. Press OK on the names of the satellites that you want to scan under ‘Satellite List’.
Press the EXIT button to close the ‘Satellite List’.
3. Press and set the ‘Search Type’ and ‘Network Search’ parameters.
▪ Search Type: Decide for which channels to search
(All channels/ Free channels only/ TV channels only).
▪ Network Search: Set ON to find more transponders (frequencies) through a Network
Information Table (NIT) scan. That is, when the broadcaster is sending a NIT through a given
transponder, the receiver will also scan for transponders listed in the NIT and not otherwise
recognized. (this can happen when a transponder is new)
4. Press RED buttom under ‘SCAN’ to scan the selected satellites. <Figure 6.1.7>
[2012.10.12]D15+F15_russian+english.indd 91 2012-10-12 11:23:07
To Next Page
Loading...