92
6. Operation
6.1
Getting Started
▣ Manual Scan <Figure 6.1.8>
1. Select a transponder.
2. To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC buttons.
3. To add a new transponder, press the GREEN button.
4. To delete a transponder, press the YELLOW button with the cursor next to the Frequency
parameter.
5. To search a transponder, set its different parameters and press RED button.
▣ Package Identifier (PID) Scan <Figure 6.1.9>
1. Select a transponder.
2. To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC buttons.
3. To add a new transponder, press the GREEN button.
4. To delete a transponder, press the YELLOW button with the cursor next to the Frequency parameter.
5. To search a transponder, set its different parameters and press
You can search a specific channel of the transponder by setting its PID data (Video, Audio and PCR).
Figure 6.1.8 Figure 6.1.9
✽ Note: If you cannot access programs after correctly completing a scan procedure,
please contact your seller or your installer.
[2012.10.12]D15+F15_russian+english.indd 92 2012-10-12 11:23:07
To Next Page
Loading...