88
6. Operation
6.1
Getting Started
(When the DiSEqC Motor parameter is set as 1.2)
Figure 6.1.3
▪ Motor Step: Select Motor Step
▪ Move: Move the dish position to west/east by pressing buttons.
▪ Go To: Go to the position of the saved satellite.
▪ Motor Control: Control motor by press OK button ot the remote.
▫ Recalculate: Recalculate the position of all other saved satellites relative to the
known position.
▫ Reset System: Reset the position of all saved satellites.
▫ Goto Reference: Move the dish to the 0 position.
▫ Set West Limit: Edit & Save west limit by pressing or OK buttons.
▫ Set East Limit: Edit & Save east limit by pressing or OK buttons.
▫ Enable Limit: Enable the saved east and west limit.
▫ Disable Limit: Disable east and west limit.
▫ Save: Save the current setting of DISEqC 1.2 system.
[2012.10.12]D15+F15_russian+english.indd 88 2012-10-12 11:23:06
To Next Page
Loading...