Dräger Evita 4 - Replacing the Paediatric Flow PCB

5664.500/800 Evita 4/Evita 2 dura 06/98 Repair Instructions Page 33
For internal use only. Copyright reserved. GBR5664500T055664800.fm 18.03.99
Dräger Medizintechnik
D
4.3 Replacing the Paediatric Flow PCB
• Switch the Evita off.
• Remove the Paediatric Flow PCB.
• Install the new Paediatric Flow PCB in the Evita.
• Secure the Paediatric Flow PCB with the screws.
• Check the Evita by following the instructions in the Evita Test Certificate.
Fig. 21: Component mounting diagram of the Paediatric Flow PCB
X3
1
X4
X1
X2
1
1
X12
X5