5664.500/800 Evita 4/Evita 2 dura 06/98 Repair Instructions Page 58
For internal use only. Copyright reserved.
GBR5664500T055664800.fm 18.03.99
Dräger Medizintechnik
D
• Remove the plug-in connectors from the Graphics Controller PCB.
• Remove the Graphics Controller PCB.
• Remove D29 and D40 from the old Graphics Controller PCB.
• Mount D29 and D40 onto the new Graphics Controller PCB.
• Mount the new Graphics Controller PCB by following the reverse method for
dismounting.
• Load the corresponding software into the Graphics Controller PCB.
• Check the Evita 4 by following the instructions in the Evita 4 Test Certificate.
10.4 Tests possible in DS mode
10.4.1 Diagnosis mode
refer to section of "Repair Instructions - Service No./ Modi, Error list" chapter 3.2.1,
Diagnosis page “Microprocessor” of “Front”, page 64.
10.4.2 External DS mode using PC
refer to section of "Repair Instructions - Service No./ Modi, Error list" chapter 9.5, Testing
“Front panel”, page 150.
To Next Page
Loading...
