SOFTWARE UPDATE PROCEDURE (continued) NM2C
7.6.5 Primary Service Menu
At the SST Main Menu, move the cursor to ENTER PRIMARY SERVICE and
press ENTER. Software installation and other service functions are entered
through this screen, shown in Figure 7-8.
MACHINE ID: NM2C
SERIAL NUMBER: 00011066
ACCESS LEVEL: VIEW SERVICE ID:
Load System Software
Service Log
SV50105
SOFTWARE VERSION: 1.20
SYSTEM FEATURES: 0003
Press arrow keys to change menu items, return to activate sub-screen
F10 PREVIOUS MENU
Figure 7-8: PRIMARY SERVICE MENU
-- With the flashing cursor at ACCESS LEVEL, press ENTER.
-- Use the up or down arrow key to select the desired mode and press
ENTER. The following service modes are available:
VIEW: For verifying machine configuration and status
SERV: For unscheduled service
PMS: For scheduled Periodic Manufacturer’s Service
INST: For initial installation
-- Type in your ID on the ORDM or (external PC) keyboard and press
ENTER again.
-- Move the cursor with the up or down keys to select the desired functions.
These are described in the following paragraphs.
Rev. G
7-12
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
