Pocket Guide Oxylog 3000 plus 31
Alarms
Alarms
In the event of an alarm
z The indicator (A) flashes red or yellow, or lights up
yellow.
And
z The alarm message appears on the upper right cor-
ner of the screen (C). In addition, alarm tones are is-
sued.
When the fault has been remedied the alarm tone is
cancelled.
Alarms, which have been remedied and remain on the
display, can be acknowledged (reset):
z Press the Alarm Reset key (B).
The alarm message is now removed from the display.
Every alarm which has been remedied, but not acknow-
ledged, will be overwritten when a new alarm is issued.
Suppress alarm tones
z Press the key .
The alarm indicator remains active and all alarm to-
nes are suppressed for approximately 2 minutes.
Alarm tones are resumed by the device after these
2minutes.
If alarm tones are to be heard again before the
2 minutes have expired:
z Press the key again.
Setting alarm limits
Setting upper alarm limit for Paw
z Set the maximum airway pressure Pmax via the
Pmax control (A).
NOTE
The Oxylog 3000 plus Pocket Guide is not a replacement or substitute for the Instructions for Use.
Any use of the device requires full understanding and strict observation of the Instructions for Use.
024
025
To Next Page
Loading...
Need help?
General
