Dräger X-AM 5000 Technical Manual

11
Configuration
XXS OV [ppm] 0 to 200 10 Yes No 20 No Yes
XXS OV A [ppm] 0 to 200 10 Yes No 20 No Yes
XXS Odorant [ppm] 0 to 40 10 Yes No 20 No Yes
XXS Amine [ppm] 0 to 100 10 Yes No 20 No Yes
XXS COCI
2
[ppm] 0 to 10 0.1 Yes No 0.2 No Yes
XXS O
3
[ppm] 0 to 10 0.1 Yes No 0.2 No Yes
XXS NO
2
LC [ppm] 0 to 50 0,5 Yes No 1,0 No Yes
1) Different settings can be selected to meet customer requirements on delivery. The current setting can
be checked and changed with the Dräger CC Vision software. A version of Dräger CC-Vision suitable
for the Dräger X-am 5000/2000 can be downloaded on the product page of the X-am 5000:
www.draeger.com.
2) In the case of O
2
A1 is the lower alarm setpoint: an alarm is issued if the value is too low.
DrägerSensor Measuring
range
1)
Alarm A1
1)
Alarm A2
1)
setpoint can be acknowledged self-latching setpoint can be acknowledged self-latching

Dräger X-AM 5000 Specifications

General

Ingress Protection	IP67
Operating Humidity	10 to 95% RH, non-condensing
Detection Principle	Electrochemical, Catalytic, Infrared
Gases Detected	O2, CO, H2S, NO2, SO2, H2
Number of Gases	Up to 5
Display	Graphical LCD with backlight
Alarm Indicators	Audible, visual, and vibration alarms
Operating Temperature	-20 °C to +50 °C
Data Logging	Yes
Certifications	ATEX, IECEx, CSA
Response Time	T90 < 15 seconds (sensor dependent)