Dräger X-AM 5000 Technical Manual

18
Operation
Calling the Quick Menu
 Only the fresh air calibration is activated in the quick menu on delivery. The PC
software Dräger CC Vision can be used to activate the bump test for the quick menu
and/or the function for displaying and deleting peak values.
 In measuring mode, press the key three times.
If no functions have been activated in the quick menu, the device remains in
measuring mode.
 You can select the activated functions of the quick menu by pressing the key.
 Press the key to call the selected function.
Possible functions of the quick menu
 Press the key to cancel the active function and to switch to measuring mode.
 If no key is pressed for 60 seconds, the device returns automatically to measuring
mode.
Bump test, refer to page 40
Fresh air calibration, refer to page 46
Delete peak values, refer to page 19
Display pump information, refer to page 23
Activate or deactivate pump, refer to page 23
OK

Dräger X-AM 5000 Specifications

General

Ingress Protection	IP67
Operating Humidity	10 to 95% RH, non-condensing
Detection Principle	Electrochemical, Catalytic, Infrared
Gases Detected	O2, CO, H2S, NO2, SO2, H2
Number of Gases	Up to 5
Display	Graphical LCD with backlight
Alarm Indicators	Audible, visual, and vibration alarms
Operating Temperature	-20 °C to +50 °C
Data Logging	Yes
Certifications	ATEX, IECEx, CSA
Response Time	T90 < 15 seconds (sensor dependent)