Draytek Vigor2960 series - Page 110

Vigor2960 Series User’s Guide
102
Available parameters are listed as follows:
Item Description
Profile
Display the name of the LAN profile.
Enable
Check this box to enable this profile.
Mode
Choose Automatic Setting or Manual Setting.
Automatic Setting – It is not necessary to configure Start
IP, End IP and DNS setting. The system will assign suitable
address automatically.
Manual Setting – You should type the Start IP address and
End IP address manually.
Start IP
Set the starting IP address of the IP address pool for DHCP
server. The format the IP address shall be similar to the
following example:
2000:0000:0000:0000:0000:0000:0000:10 or 2000::10.
End IP
Set the ending IP address of the IP address pool for DHCP
server. The format the IP address shall be similar to the
following example:
2000:0000:0000:0000:0000:0000:0000:10 or 2000::10.
DNS
It is available when Manual Setting is selected as Mode.
Set the private IP address for DNS server. If this field is
blank, users on LAN will treat Vigor2960 as the DNS server.