Vigor2960 Series User’s Guide
402
Cancel
Click it to discard the settings configured in this page.
Enter all of the settings and click Apply.
4
4
.
.
1
1
5
5
.
.
6
6
A
A
c
c
c
c
e
e
s
s
s
s
C
C
o
o
n
n
t
t
r
r
o
o
l
l
This page allows you to open or close the web user interface of Vigor2960 by using Telnet,
SSH, HTTP, HTTPS… and etc…
Available parameters are listed as follows:
Item Description
Default: Disable
Auto-Logout
Enable – Vigor router will auto logout based on the
specified time setting (e.g., 1, 3, 5 and 10 minutes).
Disable – Default setting. The function of Auto-Logout will
be disabled.
Use Validation Code
Enable – While accessing into the web user interface of
Vigor router, a validation code will appear to authenticate
the user trying to log into web user interface.
Disable – No validation will be done when a user tries to log
into the web user interface of Vigor router.
Fail Times to Trigger
The number selected here means the times for login failure
that will trigger Validation Code for authentication. The
default setting is "0". That means no failure of login is
allowed.
Internet Access Control
Web Allow
Click Enable to allow system administrator to login from the
Internet and management the web page of the router.
Telnet Allow
Click Enable to allow system administrator to login from the
telnet and management the web page of the router.
SSH Allow
Click Enable to allow system administrator to login from the
SSH server and management the web page of the router.
To Next Page
Loading...
Need help?
General
