Vigor2960 Series User’s Guide
193
Item Description
Firewall>>Filter Setup>>IP Filter/Application Filter.
Packet Inspection
Disable – No inspection will be performed.
Enable – Packet inspection will be performed.
Packets Number
If Packet Inspection is enabled, choose a packet number for
filtering. Available settings are from 4 to 16. For example,
“8” is selected as packet number setting. It means only the
former 8 packets will be filtered and inspected by Firewall
rule. Others are allowed to pass through without any
inspection.
Apply
Click it to save the configuration.
Cancel
Click it to discard the settings configured in this page.
After finished the above settings, click Apply to save the configuration.
To Next Page
Loading...
