Draytek Vigor2960 series User Manual

Vigor2960 Series User’s Guide
329
Name
PPTP User Name/
SSL User Name
Type a user name for authentication in PPTP/SSL
connection.
PPTP Password/
SSL Password
Type a password for authentication in PPTP/SSL connection.
Local IP/Subnet
Mask
Type the IP address and subnet mask of local host.
Remote IP / Subnet
Mask
Type the LAN IP address and LAN subnet mask for the
remote host.
Route / NAT Mode
Specify the purpose for such profile.
Netbios Naming
Packet
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable – When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Multicast via VPN
Some programs might send multicast packets via VPN
connection.
 Enable – Click this button to let multicast packets pass
through the router.
 Disable – This is default setting. Click this button to let
multicast packets be blocked by the router.
RIP via VPN
 Enable – Click it to exchange routing information
protocol packets via VPN connection.
 Disable – Disable such function. This is default setting.
Apply
Click it to save the configuration.
Cancel
Click it to exit the page without saving the configuration.
4. Enter all of the settings and click Apply.
5. A new PPTP/SSL Dial-Out VPN profile has been created.

Draytek Vigor2960 series Specifications

General

Brand	Draytek
Model	Vigor2960 series
Category	Firewall
Language	English