Vigor2960 Series User’s Guide
353
2. Simply click the Add button.
3. The following dialog will appear.
Available parameters are listed as follows:
Item Description
Profile
Type the name of the profile that you create.
IP Address
Type the IP address for this protocol.
Port
Specify the port used for this protocol. The default setting is
5900.
Scaling
Chose the percentage (100%, 80%, 60%) for such
application.
Apply
Click it to save the configuration.
Cancel
Click it to exit the page without saving the configuration.
4. Enter all of the settings and click Apply.
5. A new SSL Application profile has been created.
To Next Page
Loading...
Need help?
General
