Draytek Vigor2960 series User Manual

Vigor2960 Series User’s Guide
394
recognized by VigorACS.
Auto Failover to Active
WANs
Specify the WAN interface to take over the job of network
connection when the original WAN interface fails.
ACS Server URL/
ACS Server Username /
ACS Server Password
Such data must be typed according to the ACS (Auto
Configuration Server) you want to link. Please refer to Auto
Configuration Server user’s manual for detailed information.
Last Inform Response
Time
Display the response time informed by VigorACS.
ACS Connection Status
When it lights in green, it means the router has been detected
and can be managed by VigorACS.
Port
Type the port number for Vigor2960 which will be
recognized by VigorACS.
CPE URL
Display the URL of such CPE.
CPE Username
Type the user name for the CPE which will be used by the
administrator of VigorACS to log into the WUI of
Vigor2960.
CPE Password
Type the password for the CPE which will be used by the
administrator of VigorACS to log into the WUI of
Vigor2960.
Turn on log message to
syslog
The default setting Disable. Click Enable to make the log
message being recorded by Syslog.
Periodic Status
The default setting is Enable. Please set periodic time for
VigorACS to send notification to CPE. Or click Disable to
close the mechanism of notification.
Periodic Time
Set the time for VigorACS to send notification to CPE.
Enable STUN
Enable/Disable - The default is Disable. If you click
Enable, please type the relational settings listed below:
Server Address – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the
CPE must send binding request to the server for the purpose
of maintaining the binding in the Gateway. Please type a
number as the minimum period. The default setting is “60
seconds”.
Maximum Keep Alive Period – If STUN is enabled, the
CPE must send binding request to the server for the purpose
of maintaining the binding in the Gateway. Please type a
number as the maximum period. A value of “-1” indicates
that no maximum period is specified.
Apply
Click it to save the configuration.
Cancel
Click it to discard the settings configured in this page.
Enter all of the settings and click Apply.

Draytek Vigor2960 series Specifications

General

Brand	Draytek
Model	Vigor2960 series
Category	Firewall
Language	English