Vigor2960 Series User’s Guide
67
reply received by the router, the connection of WAN
interface will be regarded as breaking down.
Apply
Click it to save the configuration and exit the dialog.
Cancel
Click it to exit the dialog without saving the configuration.
If you choose DHCP as IPv4 protocol type, click the DHCP Tab to open the
following page:
Available parameters are listed as follows:
Item Description
Host Name
(Optional)
Type a name as the host name for identification.
IP Alias
Type other IP addresses to be bound to this interface. This
setting is optional. If you have typed addresses here, you can
see and choose it in later web page settings (e.g.,
NAT>>Port Redirection.
Add – To add a new IP address, click Add. Type the IP
address and use the drop down list to specify the subnet
mask. Next, click Save. The new one will be added and
displayed on the field under the box.
Save – Click this button to save the setting.
MTU/MRU
It means Max Transmit Unit for packet. The default setting
is 1500.