Draytek VigorAP 910C - Page 102

VigorAP 910C User’s Guide
92
Extension Channel
With 802.11n, there is one option to double the bandwidth per
channel. The available extension channel options will be varied
according to the Channel selected above. Configure the
extension channel you want.
Rate
If you choose 11g Only or 11b Only, such feature will be
available for you to set data transmission rate.
PHY Mode
Display the PHY Mode specified for such device.
Security
Select WEP, TKIP or AES as the encryption algorithm.
Peer Mac Address
Four peer MAC addresses are allowed to be entered in this
page at one time.
Packet-OVERDRIVE
This feature can enhance the performance in data transmission
about 40%* more (by checking Tx Burst). It is active only
when both sides of Access Point and Station (in wireless
client) invoke this function at the same time. That is, the
wireless client must support this feature and invoke the
function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for matching
with Packet-OVERDRIVE (refer to the following picture of
Vigor N61 wireless utility window, choose Enable for
TxBURST on the tab of Option).