Draytek VigorAP 910C User Manual

VigorAP 910C User’s Guide
42
of the network. (Default: 255.255.255.0/ 24)
Default Gateway – In general, it is not really necessary to
specify a gateway for VigorAP 910C. However, if it is required,
simply type an IP address as the gateway for VigorAP 910C. It
will be convenient for the access point acquiring more service
(e.g., accessing NTP server) from Vigor router.
Enable Management VLAN – VigorAP 910C supports
tag-based
VLAN for wireless clients accessing Vigor device. Only the
clients with the specified VLAN ID can access into VigorAP
910C.
VLAN ID – Type the number as VLAN ID tagged on the
transmitted packet. “0” means no VALN tag.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. DHCP
server can automatically dispatch related IP settings to any local
user configured as a DHCP client.
Enable Server / Disable Server - Enable Server lets the modem
assign IP address to every host in the LAN.
Disable Server lets you manually or use other DHCP server to
assign IP address to every host in the LAN.
Relay Agent - Specify which subnet that DHCP server is located
the relay agent should redirect the DHCP request to.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the 1st IP
address of your modem is 192.168.1.2, the starting IP address
must be 192.168.1.3 or greater, but smaller than 192.168.1.254.
End IP Address - Enter a value of the IP address pool for the
DHCP server to end with when issuing IP addresses.
Subnet Mask - Type in an address code that determines the size
of the network. (Default: 255.255.255.0/ 24)
Default Gateway - Enter a value of the gateway IP address for
the DHCP server.
Lease Time - It allows you to set the leased time for the
specified PC.
DHCP Server IP Address for Relay Agent - It is available
when Enable Relay Agent is selected. Set the IP address of the
DHCP server you are going to use so the Relay Agent can help to
forward the DHCP request to the DHCP server.
Primary IP Address - You must specify a DNS server IP
address
here because your ISP should provide you with usually
more than
one DNS Server. If your ISP does not provide it, the
modem will
automatically apply default DNS Server IP address:
194.109.6.66
to this field.
Secondary IP Address - You can specify secondary DNS server
IP address here because your ISP often provides you more than
one DNS Server. If your ISP does not provide it, the modem will
automatically apply default secondary DNS Server IP address:

Draytek VigorAP 910C Specifications

General

Brand	Draytek
Model	VigorAP 910C
Category	Wireless Access Point
Language	English