52
[702] - Second International Options Code
[703] - Delay Between Dialing Attempts
For standard (force) dialing, the panel will go off-hook, search
for dialtone for 5 seconds, hang-up for 20 seconds, go off-hook,
search for dialtone for 5 seconds, then dial. If there is no initial
handshake recognized within 40 seconds, the panel will hang
up. This programmable timer adds a delay before the next call is
attempted, and is defaulted to 001 for a total of six seconds.
5.10 Module Programming
The programming sections listed below pertain to additional
modules on the system. For instructions on programming these
modules and a description of each programming section, see the
associated installation manuals.
1. PC5400 ProgrammingSection [801]
2. PC5936 ProgrammingSection [802]
• PC5936 Audio Interface will allow you to connect to 16 Inte-
rior (PC5921) or exterior (PC5921EXT) Intercom Station.
These surface mounted stations contain a speaker and a
microphone. This module enables: Page/Answer, Do Not Dis-
turb, Baby Monitor, Answer Incoming Calls, Doorbell Func-
tion, and Background Music features in your alarm. This
module also has the Listen-in feature for central station moni-
toring. The central station can select the audio station, listen/
talk, extend on-line time and hang up. The Listen-In feature
can be enabled separately for telephone numbers 1/3 and
2.
All talk/listen and/or video sessions will be disconnected if the
panel needs to communicate alarms to the central station.
• Alternate Communicator ProgrammingSection [803]
• PC5132 ProgrammingSection [804]
• PC5100 ProgrammingSection [805]
• PC5108L ProgrammingSection [806]
NOTE:
All talk/listen and/or video sessions are disconnected when
the panel communicates alarms to the central station.
Telephone 1 & 3 Listen-In Enabled . . . . Section [381], Option 5
Telephone 2 Listen-In Enabled . . . . . . . Section [381], Option 6
Periodic Camera Test
When the Periodic Camera Test option is enabled, the panel
will test cameras connected to a PC5108L module every 30 min-
utes. Only cameras with the Camera Test option enabled will be
tested. See your PC5108L Installation Manual for more informa-
tion on camera tests.
If the Local Mode option is ON, the panel will send events to
the PC5108L Module, Downlook will not be initiated if
requested. If the Local Mode option is OFF, the panel will send
communicated events to the PC5108L Module. Downlook will
initiate when requested. See your PC5108L Installation Manual
for more information.See Periodic Camera Test Section [017],
Option [7] and Local Mode Enabled/Disabled Section [381],
Option [8]
[702] SECOND INTERNATIONAL OPTION CODES
Option International Code On/Off Description
1 Pulse Dial ON Pulse Dialing Make/Break Ratio is 33/67
OFF Pulse Dialing Make/Break Ratio is 40/60
2 Force Dial ON Force Dialing Enabled. If the first attempt by the panel to call the monitoring station
fails to detect a dialtone, on every subsequent attempt the panel will dial regardless of the
presence of dialtone. See {703] Delay Between Dialing Attempts
OFF Force Dialing Disabled. The panel will not dial the programmed telephone number if
dialtone is not present.
3 Land Line Test Transmission ON Land Line Test Transmission Interval is in Minutes. The value programmed in Section
[370] Seventh entry is in Minutes.
OFF Land Line Test Transmission Interval is in Days. The value programmed in Section
[370] Seventh entry is in Days.
4 Handshake ON 1600 Hz Handshake. The communicator responds to a 1600 Hz handshake for BPS for-
mats.
OFF Standard Handshake. The communicator responds to the handshake designated by the
format selected (1400 or 2300 Hz).
5 I.D. Tone ON I.D. Tone Enabled. After the telephone number is dialed, the panel will emit a tone (as
specified by Option 6) for 500 ms every two seconds to indicate that it is a digital equip-
ment call, not voice.
OFF I.D. Tone Disabled.
6 I.D. Tone Frequency ON 2100 Hz I.D. Tone
OFF 1300 Hz I.D. Tone
7 DLS Window ON One Time 1-hour user Enabled DLS Window. The User Enabled DLS Window is 1 hour
in length and will be closed after a successful hang-up from a downloading call.
OFF Full 6-hour User Enabled DLS Window. The User Enabled DLS Window is 6 hours in
length and remains open after a successful hang-up from a downloading call. This option
determines the length of the DLS window available on power up.
8 FTC Bell ON Bell on FTC when armed. If a Failure to Communicate Trouble is generated while the
system is armed, the Bell output will sound for the length of Bell time-out or until the sys-
tem is disarmed.
OFF FTC Trouble only when armed. If a Failure to Communicate Trouble is generated while
the panel is armed, the Bell output will not sound but the keypad buzzer will sound trou-
ble beeps until a key is pressed.
To Next Page
Loading...
