DSC PowerSeries Neo

Menu Description
---Z-Wave Home ID
1
Press [*] to query the Z-Wave network Home ID. If the ID is 0, verify that the
module has communicated with Alarm.com and that the Alarm.com account is set
up for Z-Wave.
---Extended Range Option Press [*] to enable/disable extended range
---Communications Test Press [*] to perform ADC communication test
User Functions
Press [*][6] [Master Code] to enter User Functions menu. Then scroll to Interactive Services
Menu Description
--HSPA Module Status See Installer Programming section
---Radio See Installer Programming section
---HSPA Freq. See Installer Programming section
--SN See Installer Programming section
---SIM card See Installer Programming section
---Version See Installer Programming section
---Advanced - Network See Installer Programming section
--Z-Wave Setup
1
See Installer Programming section
---Number of Z-Wave Devices
1
See Installer Programming section
---Add Z-Wave Device
1
See Installer Programming section
---Remove Z-Wave Device
1
See Installer Programming section
---Z-Wave Home ID
1
See Installer Programming section
--Communication Test See Installer Programming section
1
Refer to the Home Automation installation instructions and guides on the Alarm.com Dealer Site for more
information on Z-Wave enrollment and troubleshooting.
- 22 -