DSC PowerSeries PC1616 Installation Guide

Chapter 5 Programming Worksheets
33
[013] First System Options
[014] Second System Options
[015] Third System Options
[016] Fourth System Options
Opt Def ON OFF
1

Normally Closed Loops


End-of-Line Resistors
2

Double End-of-Line Resistors


Single End-of-Line Resistors
3


Panel shows all Troubles when armed

Panel shows only Fire Troubles when armed
4

Tampers/Faults do not show as open


Tampers/Faults show as open
5


Auto-Arm Schedule in [*][6] and installers

Auto-arm Schedule in Installer Programming Only
6


Audible Exit Fault Enabled

Audible Exit Fault Disabled
7


Event Buffer Follows Swinger Shutdown

Event Buffer Logs Events past Shutdown
8

Temporal Three Fire Signal Enabled


Standard Pulsed Fire Signal
Opt Def ON OFF
1

Arm /Disarm Bell Squawk Enabled


Arm /Disarm Bell Squawk Disabled
2

Bell Squawk During Auto-Arm


No Bell Squawk During Auto-Arm
3

Bell Squawk On Exit Delay


No Bell Squawk On Exit Delay
4

Bell Squawk On Entry Delay


No Bell Squawk On Entry Delay
5

Bell Squawk On Trouble


No Bell Squawk On Trouble
6


Audible Exit with Urgency

Silent Exit Delay
7

Exit Delay Termination Enabled


Exit Delay Termination Disabled
8

Residential Fire Bell is Continuous


Residential Fire Bell is Cut-off
Opt Def ON OFF
1


Fire Key Enabled

Fire Key Disabled
2

Panic Key Audible (Bell / Beeps)


Panic Key Silent
3

Quick Exit Enabled (ON for SIA CP-01)


Quick Exit Disabled
4


Quick Arming Enabled (No Code Required)

Quick Arming Disabled (Code Required)
5

Code Required for Bypassing


Code Not Required for Bypassing
6

Master Code NOT Changeable


Master Code Changeable
7


TLM Enabled

TLM Disabled
8

TLM Audible (Bell) when Armed


TLM Trouble Beeps when Armed
Opt Def ON OFF
1


AC Trouble Displayed

AC Trouble Not Displayed
2

Trouble Light Flashes if AC Fails


Trouble Light does NOT follow AC Status
3

Blank Keypad when Not Used


Keypad Blanking Disabled
4

Code required to remove Keypad Blanking


No Code Required
5


Keypad Backlighting is Enabled

Keypad Backlighting is Disabled
6

Power Save Mode Enabled


Power Save Mode Disabled
7

Bypass Status Displayed While Armed


Bypass Status Not Displayed While Armed
8

Keypad Tampers Enabled


Keypad Tampers Disabled

DSC PowerSeries PC1616 Specifications

General

Partitions	2
Keypads	Up to 8
Zones	6 on-board
PGMs	2
Power Supply	16.5VAC
Battery Backup	12VDC, 4Ah