EasyManuals Logo

DSC PowerSeries PC1616 Installation Guide

DSC PowerSeries PC1616
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
Appendix F: Communicator Format Options
67
SAFETY INSTRUCTIONS FOR SERVICE PERSONNEL
WARNING: When using equipment connected to the telephone network, there are basic safety instructions that should
always be followed. Refer to the Safety Instructions provided with this product; save them for future reference. Instruct the
end-user regarding the safety precautions that shall be observed when operating this equipment.
Selecting a Suitable Location for the Alarm Controller
Use the following list as a guide to find a suitable place for this equipment:
Locate the control panel near a telephone socket and a power outlet.
Select a place that is free from vibration and shock.
Place the alarm controller on a flat, stable surface and follow the installation instructions:
Do NOT locate this product where persons can walk on the secondary circuit cable(s).
Do NOT connect the alarm controller to electrical outlets on the same circuit as large appliances.
Do NOT select a place that exposes the alarm controller to direct sunlight, excessive heat, moisture, vapors, chemicals
or dust.
Do NOT install this equipment near water (e.g., bathtub, wash bowl, kitchen/laundry sink, wet basement, or near a
swimming pool).
Do NOT install this equipment and its accessories in areas where there is a risk of explosion.
Do NOT connect this alarm controller to electrical outlets controlled by wall switches or automatic timers.
AVOID sources of radio interference.
AVOID setting up the equipment near heaters, air conditioners, ventilators, and/or refrigerators.
AVOID locating this equipment close to or on top of large metal objects (e.g., metal wall studs).
Safety Precautions Required During Installation
NEVER install this equipment and/or telephone wiring during a lightning storm.
NEVER touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network
interface.
Ensure that cables are positioned so that accidents can not occur. Connected cables must not be subject to excessive
mechanical strain.
For Direct Plug-in versions, use the transformer supplied with the device.
The power supply must be Class II, FAIL SAFE with double or reinforced insulation between the PRIMARY and
SECONDARY circuit/ENCLOSURE and be an approved type acceptable to the local authorities. All national wiring rules
shall be observed.

Other manuals for DSC PowerSeries PC1616

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DSC PowerSeries PC1616 and is the answer not in the manual?

DSC PowerSeries PC1616 Specifications

General IconGeneral
Partitions2
KeypadsUp to 8
Zones6 on-board
PGMs2
Power Supply16.5VAC
Battery Backup12VDC, 4Ah

Related product manuals