DSEGenset DSE8610 User Manual

Description Of Controls
66
Example 1 continued – Modem diagnostics
Modem diagnostic screens are included; press when viewing the RS232 Serial Port instrument
to cycle the available screens. If you are experiencing modem communication problems, this
information will aid troubleshooting.
Serial Port
Serial PortSerial Port
Serial Port
RTS
RTSRTS
RTS
CTS
CTSCTS
CTS
DSR
DSRDSR
DSR
DTR
DTRDTR
DTR
DCD
DCDDCD
DCD
Line Description
RTS Request To Send Flow control
CTS Clear To Send Flow control
DSR Data Set Ready Ready to communicate
DTR Data Terminal Ready Ready to communicate
DCD Data Carrier Detect Modem is connected
Modem Commands
Modem CommandsModem Commands
Modem Commands
Rx: OK
Rx: OKRx: OK
Rx: OK
Tx: AT+IPR=
Tx: AT+IPR=Tx: AT+IPR=
Tx: AT+IPR=9600
96009600
9600
Rx: OK
Rx: OKRx: OK
Rx: OK
Modem Setup Sequence
1)
If the Modem and DSE8600 series communicate successfully:
2)
Shows the state of the modem communication lines. These
can help diagnose connection problems.
Example:
RTS A dark background shows the line is active.
RTS a grey background shows that the line is toggling high and
low.
RTS No background indicates that the line is inactive
Shows the last command sent to the modem and the result
of the command.

DSEGenset DSE8610 Specifications

General

Brand	DSEGenset
Model	DSE8610
Category	Controller
Language	English