Operation
75
6 OPERATION
The following description details the sequences followed by a module containing the standard ‘factory
configuration’.
Remember that if you have purchased a completed generator set or control panel from your supplier,
the module’s configuration will probably have been changed by them to suit their particular
requirements.
Always refer to your configuration source for the exact sequences and timers observed by any
particular module in the field.
6.1 ALTERNATIVE CONFIGURATIONS
Depending upon the configuration of your system by the generator supplier, the system may have
selectable configurations (for example to select between 50Hz and 60Hz running). If this has been
enabled your generator supplier will advise how this selection can be made (usually by externally
operated selector switch or by selecting the required configuration file in the DSE8600 series front
panel configuration editor).
To Next Page
Loading...
Need help?
General
