A2 158004.B00
Analog to Digital Converter: Four channel, 12-bits. External reference. 0V to +5V
input range.
Reset circuit: Power supply monitor, PC/104 bus reset, watchdog timer and
external reset switch capability.
Bus interfaces: PC/104 V2.3 16-bit (ISA bus) and PC/104-Plus 32-bit (PCI
bus).
Interrupts: Standard PC and PC/AT interrupts are available for on-board
peripherals or the PC/104 bus: (IRQ3, IRQ4, IRQ5, IRQ6,
IRQ7, IRQ9, IRQ10, IRQ11, IRQ12, IRQ14 and IRQ15).
DMA: Standard PC and PC/AT DMA request and acknowledge pairs
available on PC/104 bus. Multiple bus masters (using the
/MASTER signal) are not supported.
Connectors: Standard PC/104-Plus expansion bus connectors - male only -
TP400 must be the top board in a stack. 14-way, 16-way and
50-way right-angle headers for I/O. A 26-way flat flexible cable
for a floppy drive. A 44-way 2mm straight connector for IDE
drives. A 40-way 0.05" connector for flat panels. Two 8-pin SIL
headers for Ethernet and USB. A 4-way right angle power
connector and 3-way fan connector. SIL PanelLink connector.
Dimensions: PCB - 3.550 inches x 3.775 inches, (91.7 mm x 95.8 mm
approx.). Overall dimensions including connectors, 4.25 inches
x 3.775 inches x 1.05 inches, (108mm x 102mm x 27mm
approx). Maximum height on the component side of the PCB is
4.35 inches (13.7mm).
Weight: 180g Approx.
Operating temperature: 0 - 60 degrees C.
Humidity: 10% - 90% non-condensing.
Power Supplies: +5V only required.
1.03A typical (300MHz, graphics on)
To Next Page
Loading...