158004.B00 B7
LK113 SDRAM Clock Feedback
These links are set according to the processor fitted.
Geode GX1 Link 1 - 3 (Default)
Geode GXm Link 1 - 2 and 3 - 4
LK114 IDE /PDIAG Pin
This link is only present on the Rev B TP400 PCB. It allows pin 34 of the IDE
connector J100 to be connected to GND or to be unconnected. By default it is
connected to GND, which is equivalent to the connection on the Rev A board.
Connect /PDIAG pin to GND: Fit Link (Default)
/PDIAG is not connected; Omit Link
To Next Page
Loading...