18
3.2. Setting the environment of Wireless LAN
If you do not use wireless LAN, please skip Chapter 3.2.
3.2.1 Setting the wireless LAN connection
There are two types for wireless LAN. One is an infrastructure, a connection via access point (AP), and the
other is an ad hoc, direct connection with PC.
(1) Insert SD card into NETIMPRESS air, and then connect NETIMPRESS air to PC by USB cable.
The power of NETIMPRESS air is supplied via USB. Therefore, if you use it under the wireless LAN
environment, power supply from the target (battery) via a target probe is necessary.
If “sd card not detected” message is shown on the LCD of NETIMPRESS air, disconnect the USB
cable once, and check to make sure that SD card is fully inserted. If SD card is not inserted correctly,
setting of NETIMPRESS air is not available.
(2) Start up the air Connect.
Start up menu – All programs – YDC Tools – NETIMPRESS air Connect.
Make sure you installed AZ990 (air Connect) before connecting USB cable. For details on how to
install it, see Chapter 3.1.1 “How to install AZ990 (air Connect)”. USB driver is installed together with
AZ990.
To Next Page