DTS NETIMPRESS air - If an Error Occur During Wireless LAN Connection

25
3.2.3 If an error occur during Wireless LAN connection
Is the setting of IP address
correct?
 Check the IP address you have set for NETIMPRESS air.
➥
See Chapter 3.2.1 “Setting the wireless LAN connection”.
 Make sure not to overlap IP addresses used by another devices
connected to the same network or host PC.
 If you set an ad hoc mode, and if the host PC automatically receives
IP address (DHCP), you cannot connect NETIMPRESS air. You
must set the IP address. For access point connection, IP address
has to be set specifically if there is no DHCP server.
 Set the IP address for host PC and NETIMPRESS air based on the
setting of subnet mask.
If the subnet mask is 255.255.255.0, the upper 24 bits have to be
common by host PC and NETIMPRESS air.
Is the setting of port number
correct?
 Check the port number you have set for NETIMPRESS air. Enter
“1000” (Default) if you did not make any changes.
➥
See Chapter 3.2.1 “Setting the wireless LAN connection”.
Subnet mask
 Default of subnet mask of NETIMPRESS air is 255.255.255.0. Set
the subnet mask based on the setting of host PC.
➥
If you need to change it, see Chapter 3.2.1 “Setting the
wireless LAN connection”.