PIN CODE entering function for overriding
purposes
This function allows starting the vehicle temporarily
in case of an engine failed operation due to a
malfunction of the Immobilizer System.
If upon Key-On there is an ERROR concerning the
Immobilizer, the instrument panel automatically
activates the function to enter the PIN code.
Entering the code:
- Each time button (2) is pressed, the highlighted
number increases from 0 to 9 and then goes back
to 0; to confirm the desired number press button
(4);
- Repeat the procedure until entering the fourth
digit.
- Press button (4) again to confirm.
If the code is incorrect, the instrument panel will
show "PIN WRONG" flashing for 2 seconds and return
to the initial indication in order to enter the code again.
It the code is correct, the instrument panel will show
"PIN CORRECT" flashing for 2 seconds.
After 2 seconds, the instrument panel will return to
the "normal" view (with all indications active).
Note
There is no limit to the number of times the
code can be re-entered; the instrument panel will turn
off automatically 120 seconds after any attempt to
enter the code by indicating "TIME OUT" for 2
seconds and then it will show the main screen.
128
To Next Page
Loading...
