Lap Timer (LAP): LAP recording
This function describes the (LAP) time recording
procedure.
If this function has been enabled, lap time can be
recorded as follows:
- the first time rider presses button (3), the "timer"
of the first lap starts and "START LAP" will be
displayed flashing on the instrument panel for 4
seconds, then the previous screen will appear
again;
- from now on, every time button (3) is pressed,
the instrument panel will show the lap time
steady on for 10 seconds and then it will display
the previous screen.
30 laps max. can be recorded. If the memory is full,
each time you press button (3), the instrument panel
will not be able to save any lap time and, for 4
seconds, the display will show the message “LAP
MEM. FULL” (flashing) until the memory is reset.
When the LAP function is set disabled, the current
lap is not stored. If the LAP function is enabled and
vehicle is suddenly stopped (Key-Off), function will be
automatically disabled, even if timer was active, the
current lap will not be recorded.
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the recording function is disabled.
If, on the contrary, the LAP function is enabled and
memory was not reset, but recorded laps are less
than 30 (example: 18 recorded laps) the instrument
panel records any left lap until memory is full (in this
case 12 further laps can be recorded).
In this function only the lap times being recorded are
displayed; other data are anyway recorded (MAX
speed, MAX RPM, limiter if reached), which can be
later displayed in the recorded LAP displaying
function.
92
To Next Page
Loading...
