Clock setting function (CLOCK)
This function allows setting the clock. To display the
function, enter the setting menu and access the
"CLOCK" page. To access the setting function, keep
button (4) pressed for 3 seconds. After 3 seconds, the
"SETTING…." indication will be activated to indicate
the access to the setting function.
On entering this mode, the message AM will flash;
- if you press button (2) the "PM" indication starts
flashing;
- if you press button (2) you will return to the
previous step (if it is 00:00, when switching
between "AM" to "PM", 12:00 will be displayed);
press button (4) to shift to hour setting, hours will
start flashing;
- each time button (2) is pressed, counter will
increase in steps of 1 hour;
- keep button (2) pressed to make counter
increase in steps of 1 hour per second (hours will
not flash while button is pressed);
button (4) gives access to the minute setting mode;
minutes start to flash;
- each time button (2) is pressed, counter will
increase in steps of 1 minute;
- keep button (2) pressed to make counter
increase in steps of 1 minute per second.
- If button (2) is kept pressed for more than 5
seconds, steps increase in steps of 1 every 100
ms (seconds will not flash while button (2) is
pressed).
To confirm (store) the new set time press button (4).
"EXIT" will be automatically highlighted and by
pressing button (4) it will be possible to go back to the
setting menu.
Note
In case of battery off, when the Voltage is
restored and upon next Key-On, clock will have to be
set again (it will automatically start counting from
00:00).
98
To Next Page