Lap Timer (LAP): LAP on/off
This function allows enabling/disabling LAP (lap time)
function.
To display the function, enter the setting menu and
access the "LAP" page.
The information will be displayed as follows:
- checkmark (V) indicates the adjustment currently
in use;
- use buttons (1) and (2) to highlight the new
setting;
- to store the new adjustment, press button (4);
checkmark (V) will move on the stored condition.
To quit, highlight "EXIT" and press button (4). If "OFF"
is saved, LAP function will be disabled.
If "ON" is saved, LAP function will be enabled.
Note
When LAP function is active, button (3) takes on
the dual function of high beam Flash and LAP timer
Start/Stop.
90