Dukane DPC II Plus - Page 167

157
Dukane Manual Part No. 403–566–01
Appendix A – List of Figures
Figure 7–42 Pressure Two Weld Energy Data Entry.............................................80
Figure 7–43 Pressure Two Max Weld Time Data Entry ........................................ 79
Figure 7–44 Dual Pressure Time Only Menus ..................................................... 79
Figure 7–45 Second Pass Through Process Control Menu .................................. 79
Figure 7–46 Press Hold Time Data Entry.............................................................80
Figure 7–47 Third Pass Through Process Control Menu ...................................... 80
Figure 7–48 Press Afterburst Enable Menu ........................................................ 80
Figure 7–49 Press Afterburst Delay Data Entry ................................................... 80
Figure 7–50 Press Afterburst Duration Data Entry ..............................................80
Figure 7–51 Return to Process Control Menu..................................................... 80
Figure 7–52 Process Setup Menu .......................................................................81
Figure 7–53 Dual Pressure Welding Cycle Data .................................................. 81
Figure 7–54 Hot Keys ........................................................................................81
Figure 7–55 Min and Max Values for Hold Time ................................................ 81
Figure 7–56 Modified Hold Time .......................................................................81
Figure 7–57 Amplitude Adjust ...........................................................................82
Figure 7–58 Process Control Menu Flowchart .................................................... 83
Figure 8–1 Process Setup Main Menu ..............................................................90
Figure 8–2 Limit Definition Menu .................................................................... 90
Figure 8–3 Single Pressure Process Limits Menu ...............................................90
Figure 8–4 Limit Definition Flowchart ..............................................................91
Figure 8–5 Dual Pressure Process Limits Menu ................................................. 91
Figure 8–6 Single Pressure Max Energy Data Entry ........................................... 92
Figure 8–7 Minimum Value Error Message ....................................................... 92
Figure 8–8 Dual Pressure Limits Selection Menu ...............................................92
Figure 8–9 P1 Maximum Energy Data Entry .....................................................92
Figure 8–10 CANCEL Key Return Path Flow Chart .............................................92
Figure 9–1 Utilities Menu Flowchart................................................................. 97
Figure 9–2 Process Setup Main Menu ..............................................................98
Figure 9–3 Setup Utilities Menu .......................................................................98
Figure 9–4 Setup Utilities Selection Menu ........................................................98
Figure 9–5 Setup Types Selection Menu ...........................................................98
Figure 9–6 Enter New Setup Menu .................................................................. 98
Figure 9–7 New Setup Configuration Message ................................................98
Figure 9–8 Source File Location Entry ............................................................... 99
Figure 9–9 Destination File Location Entry........................................................99
Figure 9–10 Confirm Copy Files ......................................................................... 99
Figure 9–11 Erase Setups Selection Menu .......................................................... 99
Figure 9–12 Confirm Erase Selected Setup......................................................... 99
Figure 9–13 Erase Setup in Progress................................................................... 99
Figure 9–14 Confirm Erase All Setups .............................................................. 100
Figure 9–15 Erasing All Setups In Process.........................................................100
Figure 9–16 Part Count Selection Menu .......................................................... 100
Figure 9–17 Confirm Reset Part Count ............................................................ 100
Figure 9–18 Confirm Counter Enabled ............................................................ 100
Figure 9–19 Counter Preset Value .................................................................... 101
Figure 9–20 Status Output Mode Selection...................................................... 101
Figure 9–21 Cycle Press Selection Menu .......................................................... 101