Dukane DPC II Plus - Page 183

173
Dukane Manual Part No. 403–566–01
Index
Maximum Weld Time..................................................................67, 70, 71, 79
Menu, Confirmation ..................................................................................... 35
Menu, Data Entry ..........................................................................................35
Menu, Selection ............................................................................................ 35
Menu Flowchart ....................................................................59, 66, 68, 72, 75
Menu Keys ................................................................................... 29, 33–34, 77
Model Number Coding ............................................................................... 150
Mounted Probes.......................................................................................... 111
MODE Key .........................................................................................34, 74, 77
Mode Menu ............................................................................................. 75, 79
Model Number Tag Location ....................................................................... 19
MPC Module .................................................................................................. 50
MPC Probe, Auto Stop Menu ....................................................................... 68
“ “ , Data Entry ........................................................................... 69–71
“ “ , Maximum Weld Time................................................................ 70
“ “ , Weld Energy Menu ................................................................... 70
“ “ , Weld Method Menu .................................................................69
“ “ , Weld Time Menu.......................................................................69
Multi–Probe Control Module ....................................................................... 50
Multi–Probe Mode Flow Chart..................................................................... 68
Multiple Probe System Cabling .................................................................... 22
N
Navigation Keys (Menu Keys) .................................................... 29, 33–34, 77
O
OFF LINE Status Display ........................................................................31, 120
OFF LINE Key ................................................................................................. 30
ON LINE Status Display .........................................................................31, 119
ON LINE Key ..........................................................................................30, 119
Operational Checkout ........................................................................ 119–120
Operating Conditions ................................................................................. 148
Operational Control (Thruster) Cable.............................................. 23–24, 49
OSHA Compliance ......................................................................................... 12
Output Connector, System Status ....................................................19, 39, 42
Output, Isolated ...................................................................................... 42, 45
OVERLOAD Status Display .............................................................. 31–32. 127
OVERLOAD Status Output............................................................................43
OVERTEMP Status Display ....................................................................31, 127
OVERTEMP Status Output ............................................................................ 43
P
Parameter Values, Min–Max ........................................................................85
Part Count, Count Sus/Bad Part .................................................................100
“ “ , Menu ........................................................................................100
“ “ , Preset ........................................................................................101
Part Count, Reset ........................................................................................100
Placement of DPC..........................................................................................17