Duke FBB-EC-208 - D-3.3 Exit Program Mode; D-4.0 Level 2 Programming; D-4.1 ºF or ºC Parameter Deg; D-4.2 Change the Idle Temperature Iset

21
Installation and Operation of Flexible Batch Broiler – Electric
Theproductkeys1-8areusedforenteringnumbers
1-8. The and keysareusedtoenternumbers
0 and 9.
Thecontrolwilldisplaythetotalcooktime(thesumof
alltimercycles)asanalnon-changeableparameter.
Asanexample:
ti1-:30, SEt1-775F, PL1-5, bH1-on
ti2-1:00, SEt2-775F, PL2-0, bH2-off
totL-1:30
Afterenteringthislastparameter;Hittingthe or enter
keywilltakeyoubacktotheProductselection,sothat
youcanselectanotherproducttoprogram.
D-3.3 Exit Program Mode
To exit programming and save new entries press
theENTERkeyuntilthecontroldisplaysRdY,PrE
orLo.
To exit programming without saving entries, cycle
themainOn/Offswitchoffandon.
D-4.0 Level 2 Programming
Enterthepassword3-6-4-5andpresstheENTERkey.
D-4.1 ºF or ºC Parameter dEg
ChangestemperaturedisplayedbetweenFahrenheit
(F)andCelsius(C).
The and keysareusedto scrollthroughthe
settings.
D-4.2 Change the Idle Temperature iSEt
Thisistheset-pointtemperatureforthebroilerduring
thepreheatandidlecycles.
Thedefaultforthisparameteris740ºF.
Theproductkeys1-8areusedforenteringnumbers
1-8. The and keysareusedtoenternumbers
0 and 9.
D-4.3 Change the Idle Power Level iPL
Thisisthetopheatingelementpowerlevelduringthe
preheat cycle.
D-4.4 Change the IHeating Element Voltage
Setting CSEn
Thissettingmustbechangedtomatchthevoltagerating
oftheheatingelementsthatareinstalledintheunit..
D-4.5 Additional Factory Parameters
Theremainingparametersinthissectionarefactory
settingsandshouldnotbechanged.Thesesettings
areasfollows:
• Lot
• Hit
• Cdti
• bEEP
• PCr
• Pt i
• PSEt
• CSti
D-4.6 Exit Program Mode
To exit programming and save new entries press
theENTERkeyuntilthecontroldisplaysRdY,PrE
orLo.
To exit programming without saving entries, cycle
themainOn/Offswitchoffandon.