Duplo DC-545 HC - DC-545 with HC AUTO FEEDER Specifications

68
How to Manually Program a Job
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <SET> key.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
paper to the position for the first cut (CUT 1)
location. This value must be between 0 and 650
millimeters.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <SET> key.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
paper to the position for the second cut (CUT 2)
location. This value must be between 0 and 650
millimeters. If a second cut is not required,
enter a value of zero. Turn off the automatic
cutting setting when not using CUT2. The
machine normally does not operate.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <SET> key.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
paper to the first score (SCR.1). It is possible to
enter numerical values from 0 to 650 mm. If a
score is not needed enter 0.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
CUT1 (0–650.0)
000.0mm
CUT2 (0–650.0)
000.0mm
SCR.1 (0–650.0)
000.0mm
Docu Cutter(HCEX) 5_53-69 03.12.8, 3:11 PM68